Boiler Tune-up

Boiler Tune-up

If your boiler is not operating properly, you’re probably paying too much for warm showers. Accumulated mineral deposits reduce efficiency, resulting in wasted energy and higher bills. Don’t let an out-of-service boiler leave you cold–save money on service with this hot deal!

Boiler Tune-up
$ 139
  • check Safety Inspection
  • check Inspect Expansion Tank
  • check Inspect Oil Pumps
  • check Inspect Heat Exchanger

Boiler Tune-up Details

  1. Inspect expansion tank
  2. Inspect water feed valve
  3. Measure and record boiler pressure and temperature
  4. Check aquastat
  5. Inspect low water cut-off
  6. Check for backflow device
  7. Inspect & oil pumps
  8. Inspect, test and calibrate controls and safety mechanisms
    Safety controls are designed to shut down equipment when unsafe conditions are detected in order to prevent fires, gas leaks and other dangerous situations as well as to protect the equipment from catastrophic failure. Testing and calibrating these controls ensure safe operation of your equipment.
  9. Lubricate motors and bearings
    Lubrication prevents friction in motors which can increase electricity usage and cause equipment damage.
  10. Measure amperage and voltage of blower
    Improper voltage and amp draw increase operating costs and can shorten the life of the system components.
  11. Measure and record temperatures and system performance factors
    An accurate record of vital data can indicate potential problems and help prevent equipment breakdown.
  12. Check and adjust fan switch, pilot and pilot assembly
    An improperly adjusted fan switch and/or pilot assembly can result in excess energy usage and equipment malfunction.
  13. Inspect and clean burners as needed
    Dirty burners can cause improper combustion reducing equipment life and increasing energy usage.
  14. Inspect heat exchanger for deterioration and cracks
    Heat exchangers can deteriorate and develop cracks with age. These cracks can result in dangerous carbon monoxide leakage.
  15. Measure and record carbon monoxide levels
    High levels of carbon monoxide can cause carbon monoxide poisoning. Testing ensures proper emission levels and can help to identify heat exchanger cracks not detectable through inspection alone.
  16. Inspect gas line and flue pipe for possible leaks
    This ensures proper exhaustion of toxic gases and fumes.
  17. Test and calibrate thermostat
    Ensures that the system starts, operates, and shuts off properly.
  18. Conduct overall system assessment
    This includes items such as general system configuration and ductwork/heating pipes to check for wear, damage, improper installation and other potential issues.
  19. Review findings, make recommendations and discuss any concerns
    It’s important that you understand the condition of your heating and cooling equipment including items that may pose either immediate or future risks. You should also understand your options regarding home comfort, energy efficiency and indoor air quality. Your Comfort 24-7 Provider will review all of their findings and provide recommendations.

Angie's List 5 Star Contractor

  • star
  • star
  • star
  • star
  • star

Leave a Reply

Your email address will not be published. Required fields are marked *